Sierra 595 Guide de l'utilisateur télécharger pdf (Page 49)

Rev 1.4 Draft Mar.08 49

6: Configuring the Wireless Access

Point

• Unlock MP modem

configuration

• Enable the wireless

access point

• Set the SSID

• Configure the security

settings

• Reset the MP modem

to factory defaults

Thischapterdescribe showtousetheMP595 modemasa

wirelessaccesspoint.YoucanusetheMP

595Wasawireless

accesspointineitherNATornon‐NATmodes

.

Note: This chapter only applies to the MP 595W.

Overview

Bydefaultthewirelessaccesspointisdisabled.Themainsteps

forconfiguringtheMPmodemwirelessaccesspointare:

• Enablewirelessaccesspoint.

Optional:

• Changethepassword.

• SettheSSID.

• Setthesecuritysettings.

• EnableNAT,ifapplicable.(SeeChapter5fordetails.)

Note: Watcher is currently not available over a WAP network. You

can use Watcher over Ethernet or USB to enable the WAP interface,

but when the modem is using a WAP connection, Watcher is available

over Ethernet only.



If you want to use Watcher to configure the SSID and security

settings, connect the modem to the laptop via an Ethernet cable.

Once the MP modem is configured, you can remove the Ethernet

cable.

1. See Chapter 5 for information on enabling and configuring NAT

mode.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 85 86

Pas de commentaire

Sierra 595 Guide de l'utilisateur Page 49